
Initial Setup menu
The Initial Setup menu contains the
●Networking and I/O menu
●Fax Setup menu
●
●Send Setup menu
NOTE: Values shown with "(default)" are the
Networking and I/O
Table 2-10 Networking and I/O
Menu item | Values | Description | |
|
|
|
|
I/O Timeout | Select a value in the |
| range. The factory default |
| setting is 15 seconds. |
I/O timeout refers to the elapsed time before a print job fails. If the stream of data that the device receives for a print job gets interrupted, this setting indicates how long the device will wait before it reports that the job has failed.
Parallel Input
NOTE: This item appears only if an EIO accessory is installed.
High Speed | No | Use the High Speed setting to configure the speed that |
| Yes (default) | the parallel port uses to communicate with the host. |
|
| |
|
|
|
Advanced Functions | Enabled (default) | Use the Advanced Functions setting to enable or |
| Disabled | disable bidirectional parallel communication. |
|
|
Embedded Jetdirect | See Table |
|
|
EIO <X> Jetdirect |
|
|
|
Table 2-11 Jetdirect menus
Menu item |
| Values and Description | |
|
|
|
|
TCP/IP | Enable |
| Off: Disable the TCP/IP protocol. |
|
|
| On (default): Enable the TCP/IP protocol. |
|
|
|
|
| Host Name |
| An alphanumeric string, up to 32 characters, used to |
|
|
| identify the device. This name is listed on the |
|
|
| HP Jetdirect configuration page. The default host name |
|
|
| is NPIxxxxxx, where xxxxxx is the last six digits of the |
|
|
| LAN hardware (MAC) address. |
|
|
|
|
| IPV4 Settings | Config Method | Specifies the method that TCP/IPv4 parameters will be |
|
|
| configured on the HP Jetdirect print server. |
|
|
| Bootp: Use BootP (Bootstrap Protocol) for automatic |
|
|
| configuration from a BootP server. |
|
|
| DHCP: Use DHCP (Dynamic Host Configuration |
|
|
| Protocol) for automatic configuration from a DHCPv4 |
|
|
| server. If selected and a DHCP lease exists, DHCP |
|
|
| Release and DHCP Renew menus are available to set |
|
|
| DHCP lease options. |
|
|
|
|
ENWW | Use the Administration menu 29 |