
Table 2-11 Jetdirect menus (continued)
Menu item | Values and Description | ||
|
|
|
|
|
| SNMP Test | This test checks operation of SNMP communications |
|
|
| by accessing predefined SNMP objects on the device. |
|
|
| Select Yes to choose this test, or No to not choose it. |
|
|
|
|
|
| Select All Tests | Use this item to select all available embedded tests. |
|
|
| Select Yesto choose all tests. Select No to select |
|
|
| individual tests. |
|
|
|
|
|
| Data Path Test | This test helps to identify data path and corruption |
|
|
| problems on an HP postscript level 3 emulation device. |
|
|
| It sends a predefined PS file to the device, However, |
|
|
| the test is paperless; the file will not print. |
|
|
| Select Yes to choose this test, or No to not choose it. |
|
|
|
|
|
| Execution Time [H] | Use this item to specify the length of time (in hours) that |
|
|
| an embedded test will be run. You can select a value |
|
|
| from 1 to 60 hours. If you select zero (0), the test runs |
|
|
| indefinitely until an error occurs or device is turned off. |
|
|
| Data gathered from the HTTP, SNMP, and Data Path |
|
|
| tests is printed after the tests have completed. |
|
|
|
|
|
| Execute | No*: Do not initiate the selected tests. |
|
|
| Yes: Initiate the selected tests. |
|
|
|
|
| Ping Test |
| This test is used to check network communications. |
|
|
| This test sends |
|
|
| host, then waits for an appropriate response. To run a |
|
|
| ping test, set the following items: |
|
|
|
|
|
| Dest Type | Specify whether the target device is an IPv4 or IPv6 |
|
|
| node. |
|
|
|
|
|
| Dest IP | IPV4: Type the IPv4 address. |
|
|
| IPV6: Type the IPv6 address. |
|
|
|
|
|
| Packet Size | Specify the size of each packet, in bytes, to be sent to |
|
|
| the remote host. The minimum is 64 (default) and the |
|
|
| maximum is 2048. |
|
|
|
|
|
| Timeout | Specify the length of time, in seconds, to wait for a |
|
|
| response from the remote host. The default is 1 and |
|
|
| the maximum is 100. |
|
|
|
|
|
| Count | Specify the number of ping test packets to send for this |
|
|
| test. Select a value from 1 to 100. To configure the test |
|
|
| to run continuously, select 0. |
|
|
|
|
|
| Print Results | If the ping test was not set for continuous operation, |
|
|
| you can choose to print the test results. Select Yes to |
|
|
| print results. If you select No (default), results are not |
|
|
| printed. |
|
|
|
|
|
| Execute | Specify whether to initiate the ping test. Select Yes to |
|
|
| initiate the test, or No to not run the test. |
|
|
|
|
ENWW | Use the Administration menu 33 |