Setup menu icon 
, then Printing preferences > Paper options > Sheet load, check skew > No.
You are not recommended to disable it, unless the printer has difficulty in performing the check successfully with the substrate you are using.
While performing the skew check, the printer also measures the length of the sheet. If you disable the skew check, the printer does not measure the length of the sheet; instead, it estimates the length as four times the width. This means, for instance, that the length of the sheet is likely to be shown incorrectly in the print preview.
Maintain the paper
To maintain paper quality, follow the recommendations below.
●Store rolls covered by another piece of paper or cloth.
●Store cut sheets covered and clean or brush them before loading them in the printer.
●Clean input and output platens and cut sheet tray.
●Always keep the transparent window of your printer closed.
NOTE: Photo and coated paper requires careful handling, see The print is scuffed or scratched on page 145.
Change the drying time
You may wish to change the drying time setting to suit special printing conditions such as multiple prints where time is of higher importance or when you need to be sure ink is dry before handling.
NOTE: Most paper types require no drying time.
Select the Setup menu icon 
, then Print retrieval> Select drying time. You can select:
●Extended, to set a longer than recommended time to ensure ink is completely dry
●Optimal, to set the default and recommended time for your selected paper
●Reduced, to set a shorter than recommended time when quality is of lower importance
●None, to disable the drying time and remove your print as soon as it finishes printing
TIP: If the ink is not dry when the print is removed, it could leave ink in the output tray and marks on the print.
NOTE: If you cancel the drying time during a print, the printer may not feed and cut the paper right away due to the printhead maintenance, which runs in parallel. If the dry time is zero, the printer cuts the paper and then performs the printhead maintenance. However, if the dry time is greater than zero, the printer does not cut the paper until after the printhead maintenance has completed, even if the Form feed and cut key has been pressed.
Paper handling
ENWW | Maintain the paper 41 |
