118 Working Inside the System
Installing the Peripheral Bay
See Figure 36.
1. Observe the safety precautions, warnings, and cautions at the beginning of this chapter.
2. Position the peripheral bay so that it rests on the bottom of the chassis with the drives facing
the chassis front.
3. Using the profusion carrier support as a handle, slide the peripheral bay straight inward,
toward the center of the chassis.
4. Use even pressure to mate the connector on the back of the peripheral bay (on the peripheral
bay backplane) to the blind mate board in the chassis.
5. Install the four screws removed earlier.
6. Install the memory module cover (see “Installing the Memory Module Cover” on page 100).
OM07508
Figure 36. Peripheral Bay