Inter-Tel Axxess

Page 26

Administrator Procedures

AXXESS® ADMINISTRATOR’S GUIDE – January 2004

Trunk Programming

4. To Program an Individual Trunk: Press or the INDIVIDUAL TRUNK menu but-

ton. Then program trunk options as follows:

a. The display shows ENTER TRUNK EXTENSION. Enter the extension number of

the trunk to be programmed using one of the methods described on page 25.

b. The display shows INDIVIDUAL TRUNK OPTION. Enter one of the following

options. To view the last two options on a display phone, press the arrow (<< or

>>) menu button at the bottom of the display.

Answer Supervision: To program the answer supervision for the trunk, press or

the ANS SUPERVISION menu button. When the display shows ANS SUPERVI-

SION OPTION, press or the POLARITY REVERSE menu button for the

polarity-reversal supervision type. Or, press or the VALID CALL menu button

for Valid Call timer supervision. Or, press or the VALID + POLARITY menu

button for Valid Call timer with Polarity Reversal supervision. Then press or

ACCEPT to continue.

Caller ID: To enable or disable Caller ID, press or the CALLER ID menu but-

ton. When the display shows SET CALLER ID, press or ON to enable the fea-

ture, or press or OFF to disable i t. Then press or ACCEPT to continue.

Hybrid Balance: To set the hybrid balance of the trunk to normal or short, press

or the HYBRID BALANCE menu button. When the display shows HYBRID

BALANCE OPTION, press or the NORMAL menu button, or press or the

SHORT menu button. Then press or ACCEPT to continue.

DTMF/Dial-Pulse Signaling: To set the trunk for DTMF or dial-pulse signaling,

press or the SIGNALING menu button. When the display shows ENTER SIG-

NALING OPTION, press or the DTMF menu button, or press or the

PULSE menu button. Then press or ACCEPT to continue.

Trunk Group Number: To assign the trunk to a trunk group, press or the

TRUNK GROUP menu button. When the display shows ENTER TRUNK GRP

EXTENSION, enter the desired trunk group number using one of the methods

described on page 25.

Busy Trunk: To temporarily remove the trunk from service, press or the BUSY

TRUNK menu button. When the display shows MARK TRUNK BUSY, press

or the ON menu button, or press or the OFF menu button. Then press or

ACCEPT to continue.

c. To exit, press or ACCEPT to move backward through the prompts until you

reach the ENTER DATABASE OPTION prompt.

5. To Program A Trunk Group: Press or the TRUNK GROUP menu button. Then

program the trunk group, as follows:

a. The display shows ENTER TRUNK GRP EXTENSION. Enter the extension num-

ber of the trunk group to be programmed using one of the methods described on

page 25.

b. The display shows ENTER TRUNK GROUP OPTION. Select one of the following

options. To view the last three options on a display phone, press the arrow (<< or

>>) menu button at the bottom of the display.

1 2