Kyocera KM-C1530 manual When the Copier Is Not Operating Correctly, Symptom Cause Remedy

Troubleshooting

10

10.2When the Copier Is Not Operating Correctly

Symptom	Cause	Remedy
Nothing appears on the	If only the indicator on the	Press any key to cancel
touch panel.	Start key is lit, the copier is in	Energy Saver mode. Refer to
	Energy Save mode.	p. 2-26.
	The contrast control knob for	While looking at the touch
	the touch panel has been set	panel, adjust its contrast
	either too light or too dark.	control knob. Refer to
		p. 2-20.
	The scanner power cord or	Re-connect the scanner
	the interface cable are	power cord and the interface
	disconnected.	cable.
The indicator on the Start	An access code has not	Enter your access code
key does not light up in	been entered.	according to the instructions
green.		in “To enter an access code”.
		Refer to p. 2-28.

Even though the Start Key is	The copier is malfunctioning	Follow any messages that
pressed, no copies are made		appear on the touch panel.
	The copier is still warming up	The copier takes about 5
	after just being turned on.	minutes to warm up after it is
		turned on.
Keys on the control panel do	If the indicator on the	Press the Interrupt key to
not respond.	Interrupt key is lit, the copier	cancel the mode. Refer to
	is in Interrupt mode.	p. 2-27.

The copier cannot be turned	The power supply cord may	Plug the power supply cord
on.	have been unplugged from	into an electrical outlet.
	the electrical outlet.
	The room’s circuit breaker is	Close the room’s circuit
	tripped.	breaker.

KM-C1530 10-3