5

Basic Operations

4Adjust the paper guides to the size of the paper, and then load the

paper so that the front side of the paper (the side facing up when the package was unwrapped) faces down. Lightly slide the paper into the feed slot as much as possible so that it is ready to be fed into the copier.

?Do you wish to use the manual bypass tray to feed paper manually?

ÜFeed only one sheet of paper at a time.

ÜCopies will be made on the surface of the paper facing down when it is loaded into the manual bypass tray.

5Make sure that the screen that allows you to select the manual bypass tray paper size is displayed, and then select the desired paper size.

m For paper sizes in metric measurements, touch [Metric] to display a screen that allows you to select metric paper sizes.

m To specify a paper size other than the standard sizes listed on the screen, touch [Custom Size].

Touch , , , and

to select the desired size, and then touch [Enter].

?Do you wish to set the fractional units?

ÜTouch or until the cursor moves below the fraction that you wish to change.

?Has paper not been loaded into the manual bypass tray yet?

ÜCopies can also be made by loading paper into the manual bypass tray after selecting the paper size by touching [Paper] in the Basic screen, then touching [Bypass].

5-8

KM-C1530

Page 96
Image 96
Kyocera KM-C1530 ? Do you wish to set the fractional units?, ? Has paper not been loaded into the manual bypass tray yet?