Administrator Mode Operations 8
KM-C1530 8-27
To set the “PRT Area (Top Margin)” parameter
This parameter can be used to adjust the paper feed position in the
secondary scanning direction when making single-sided copies. In
addition, this can be adjusted for each paper type. This parameter ca n be
set between –2.0 mm and +2.0 mm, in increments of 0.2 mm.
Note)
This adjustment affects paper loaded into the standard paper drawer,
the manual bypass tray, the optional 500-sheet paper feed unit, and
the optional large-capacity cabinet.
The multipurpose paper drawer (1st drawer) is the tray that is checked
and adjusted.
The top margin of the print area is adjusted du ring manufacturing of
the copier. Normally, the top margin will not need to be adjusted.
1In the Expert User’s Mode screen,
touch [2/2], and then touch [PRT Area
(Top Margin)].
The Top Margin screen appears.
2Load paper (11 × 17L) into the 1st
drawer, and then press the [Start] key
to print out the test pattern.
The screen at the right is displayed if
the paper type dial on the 1st drawer
is set for normal paper.