AThe Memory Buffer

The camera is equipped with a memory buffer for temporary storage, allowing shooting to continue while photographs are being saved to the memory card. Up to 100 photographs can be taken in succession; note, however, that the frame rate will

drop when the buffer is full (t00). The approximate number

of images that can be stored in the buffer at current settings is shown in the exposure-count displays in the viewfinder and

control panel while the shutter-release button is pressed. The illustration at right shows the display when space remains in the buffer for about 28 pictures.

While photographs are being recorded to the memory card, the access lamp next to the memory card slot will light. Depending on shooting conditions and memory card performance, recording may take from a few seconds to a few minutes. Do not remove the memory card or remove or disconnect the power source until the access lamp has gone out. If the camera is switched off while data remain in the buffer, the power will not turn off until all images in the buffer have been recorded. If the battery is exhausted while images remain in the buffer, the shutter release will be disabled and the images transferred to the memory card.

ALive View

If a continuous release mode is used during live view photography (0 49) or in movie live k view (0 57), photographs will be displayed in place of the view through the lens while the

shutter-release button is pressed.

ASee Also

For information on choosing the maximum number of photographs that can be taken in a single burst, see Custom Setting d6 (Max. continuous release, 0 230). For information on the number of pictures that can be taken in a single burst, see page 335.

84