Q-Logic 5600 manual Radius, Security, Services, Snmp, Switch, System, Zoning

A

A – Command Line Interface Reset Command

radius

Resets the RADIUS configuration to the default values as described in Table A-14.

security

Clears the security database and deactivates the active security set. The security configuration value, autosave, and fabric binding remain unchanged.

services

Resets the switch services configuration to the default values as described in Table A-15.

snmp

Resets the SNMP configuration settings to the factory default values. Refer to Table A-13for SNMP configuration default values.

switch

Resets the switch without a power-on self test. This is the default. This reset disrupts traffic and does the following:

„Activates the pending firmware.

„Closes all management sessions.

„Clears the event log. To save the event log before resetting, refer to the ”Set Log Command” on page A-76.

To reset the switch with a power-on self test, refer to the ”Hardreset Command” on page A-34. To reset the switch without disrupting traffic, refer to the ”Hotreset Command” on page A-37.

system

Resets the system configuration settings to the factory default values. as described in Table A-16.

NOTE:	„	Because this keyword changes network parameters, the
		workstation could lose communication with the switch.
	„	This keyword does not affect installed license keys.

zoning

Clears the zoning database and deactivates the active zone set. The zoning configuration values (autosave, default visibility) remain unchanged.

59097-02 B A-47