A – Command Line Interface Set Config Command
S
zoning
Initiates an editing session in which to change switch zoning attributes. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.
| Table | |
|
|
|
Parameter |
| Description |
|
|
|
InteropAutoSave |
| Available only when the InteropMode parameter is Standard, this |
|
| parameter enables (True) or disables (False) the saving of |
|
| changes to active zone set in the switch’s permanent memory. |
|
| Refer to ”InteropMode” on page |
|
| Disabling the Autosave parameter can be useful to prevent the |
|
| propagation of zoning information when experimenting with dif- |
|
| ferent zoning schemes. However, leaving the Autosave parame- |
|
| ter disabled can disrupt device configurations should a switch |
|
| have to be reset. For this reason, the Autosave parameter |
|
| should be enabled in a production environment. |
DefaultVisibility |
| Enables (All) or disables (None) communication among the |
|
| switch’s ports/devices and the fabric in the absence of an active |
|
| zone set. The default is All. |
DiscardInactive |
| Enables (True) or disables (False) the discarding of all inactive |
|
| zone sets from that zoning database. Inactive zone sets are all |
|
| zone sets except the active zone set. The default is False. |
|
|
|
