Q-Logic 5600 manual Commands, Table A-1. Command-Line Completion

A – Command Line Interface Commands

S

A.4

Commands

The command syntax is as follows: command

keyword keyword [value] keyword [value1] [value2]

The Command is followed by one or more keywords. Consider the following rules and conventions:

„Commands and keywords are case insensitive.

„Required keyword values appear in standard font: [value]. Optional values

are shown in italics: [value].

„Underlined portions of the keyword in the command format indicate the abbreviated form that can be used. For example the Delete keyword can be abbreviated Del.

The command-line completion feature makes entering and repeating commands easier. Table A-1describes the command-line completion keystrokes.

	Table A-1. Command-Line Completion
Keystroke	Effect
Tab	Completes the command line. Enter at least one character and press
	the tab key to complete the command line. If more than one possibility
	exists, press the Tab key again to display all possibilities.
Up Arrow	Scrolls backward through the list of previously entered commands.
Down Arrow	Scrolls forward through the list of previously entered commands.
Control-A	Moves the cursor to the beginning of the command line
Control-E	Moves the cursor to the end of the command line.

The command set performs monitoring and configuration tasks. Commands related to monitoring tasks are available to all account names. Commands related to configuration tasks are available only within an admin session. An account must have Admin authority to enter the Admin Start command, which opens an admin session. Refer to the ”Admin Command” on page A-8.

The commands and their page numbers are listed in Table A-2.

A-6 59097-02 B