Q-Logic 5600 manual Pagebreak, Perf option, Table A-27. Show Port Parameters

A

A – Command Line Interface Show Command

pagebreak

Displays the current pagebreak setting. The pagebreak setting limits the display of information to 20 lines (On) or allows the continuous display of information without a break (Off).

perf [option]

Displays performance information for all ports. Refer to the ”Show Perf Command” on page A-115.

port [port_number]

Displays operational information for the port given by [port_number]. Ports are numbered beginning with 0. If [port number] is omitted, information is displayed for all ports. Table A-27describes the port parameters.

	Table A-27. Show Port Parameters
Entry	Description
AIinit	Incremented each time the port begins AL initialization.
AIinitError	Number of times the port entered initialization and the initializa-
	tion failed.
Bad Frames	Number of frames that have framing errors.
ClassXFramesIn	Number of class x frames received by this port.
ClassXFramesOut	Number of class x frames sent by this port.
ClassXWordsIn	Number of class x words received by this port.
ClassXWordsOut	Number of class x words sent by this port.
ClassXToss	Number of times an SOFi3 or SOFn3 frame is tossed from
	TBUF.
DecodeError	Number of decode errors detected
EpConnects	Number of times an E_Port connected through ISL negotiation.
FBusy	Number of times the switch sent a F_BSY because Class 2
	frame could not be delivered within ED_TOV time. Number of
	class 2 and class 3 fabric busy (F_BSY) frames generated by
	this port in response to incoming frames. This usually indicates
	a busy condition on the fabric or N_Port that is preventing deliv-
	ery of this frame.
Flowerrors	Received a frame when there were no available credits.
FReject	Number of frames from devices that were rejected.
InvalidCRC	Invalid CRC detected.

59097-02 B A-95