Q-Logic 5600 Reset Command, Syntax reset, Keywords config configname, Factory, Port portnumber

A – Command Line Interface Reset Command

S

Reset Command

Resets the switch configuration parameters. If you omit the keyword, the default is Reset Switch.

Authority Admin session

Syntax reset

config [config_name]

factory

port [port_number] radius

security services snmp

switch (default) system zoning

Keywords config [config_name]

Resets the configuration given by [config_name] to the factory default values for switch, port, port threshold alarm, and zoning configuration as described in Table A-9through Table A-12. If [config_name] does not exist on the switch, a configuration with that name will be created. If you omit [config_name], the active configuration is reset. You must activate the configuration for the changes to take effect. for switch, port, and port threshold alarm configuration default values.

factory

Resets switch configuration, port configuration, port threshold alarm configuration, zoning configuration, SNMP configuration, system configuration, security configuration, RADIUS configuration, switch services configuration, and zoning to the factory default values as described in Table A-9through Table A-17. The switch configuration is activated automatically.

NOTE:	„	Because this keyword changes network parameters, the
		workstation could lose communication with the switch and
		release the Admin session.
	„	This keyword does not affect installed license keys.

port [port_number]

Reinitializes the port given by [port_number]. Ports are numbered beginning with 0.

A-46 59097-02 B