Toshiba DP125F, Dp120F manual Recording Unit Cleaning Procedure

When the Recorded Image is not Clear... - continued

Recording Unit Cleaning Procedure

1 Open the Top Cover

2 Remove the

Developer Assembly

(with Drum Unit)

3 Wipe the Glass Surface of Laser Unit

4 Clean the Transfer

Wire and Discharge

Wire

5 Clean the Paper Guide

Top Cover

Release Lever

037

Grasp the Top Cover Release Lever to open the Top Cover.

NOTE:

If a problem with the Record- ing Unit remains after this action, you may require a new developer assembly or drum unit.

Check for dirt or paper un- der the developer assembly (with drum unit) first. Call your service representative for assistance.

Developer

Assembly

051

Remove the Developer Assem- bly (with the Drum Unit at- tached).

IMPORTANT:

•Never touch the photo- conductive drum (the green surface) of the Drum Unit. If the surface is scarred or scratched, it will cause print quality problems.

•Do not expose the pho- toconductive drum of the Drum Unit to light for more than 3 minutes. If the Drum Unit is to be left anywhere outside the facsimile, be certain to cover it with cloth, pa- per, etc.

Glass

103-1

Wipe the glass surface of the laser unit with a soft dry cloth (lens cleaner cloth).

104

Clean the Transfer Wire and Discharge Wire with a cotton swab.

CAUTION:

Do not touch the Transfer Wire and Discharge Wire with your hands. The oils from your hands could con- taminate the wire resulting in lower print quality.

105

Wipe the Paper Guide with a dry cloth.

237