Toshiba Dp120F, DP125F manual Quick Start, Terminal ID, Transmitting, Receiving

- QUICK START

This section provides several quick start programming steps to prepare your new facsimile for immediate use.

These procedures are a simple version of the detailed proce- dures listed in the manual. Next to each procedure heading is a convenient page number refer- ence for the detailed procedure. Should you have any difficulty with these simple procedures, refer to the pages listed for more information.

It is highly recommended that you take the time to read through this manual to get the most from your new TOSHIBA facsimile.

Terminal ID

1 Setting the Terminal ID (Page 42)

Press:	,	,		SET TERMINAL ID
				TEL NUMBER (MAX 20)
SET TERMINAL ID
ID NAME =(MAX 40)			Enter your facsimile’s telephone
			number, press:
Displayed for 2 seconds
Enter	your user	ID (company	If the Line-2 board is		installed,
name) using the Keyboard (see
			set the international		code and

page 36) and Numeric Keypad,	facsimile’s telephone number for
press:
	line-2.
	OPERATION COMPLETED
INT. CODE?
1.ADD+
2.NOT NEEDED	Displayed for 2 seconds
If you communicate internation-
ally, select:	1.LANGUAGE
	2.DATE & TIME
	3.TERMINAL ID
	4.DIAL TYPE
Otherwise, select:
	Press:

Transmitting

2 Sending a Facsimile (Page 101)

Load your document face down into the Document Tray.

MAY-17-00 WED11:49

RESIDUAL MEMORY 100% ENTER TEL NUMBER

Dial the remote facsimile using the Dial Keypad located on the Operation Panel. Remember to include any access numbers

such as 9 or press the af-

ter the access number if you normally have to wait for a dial tone.

After the remote facsimile num- ber has been entered using the keypad, press the green START key.

Receiving

3 Receiving a Facsimile (Page 112)

Your TOSHIBA facsimile has been preset from the factory to receive facsimile messages. No special setup is required to re- ceive facsimile messages.

34