Toshiba DP125F, Dp120F manual Error Codes Printed on Reports

Error Codes Printed on Reports

When an Error Code is printed as a status indication on Transmission Reports, etc., refer to the following description for the applicable Error Code to determine the cause.

Error	Cause	How to Correct
Code
10	Paper Empty	Load recording paper and set the
		tray.
11	Recording Paper Jam	Open the top cover and clear the
		recording paper jam.
12	Document Paper Jam	Remove the jammed document.
13	Operation Panel or Top Cover	Close the cover or the panel, then
	Open	retry.
20	Power Failure	Retry the transmission or ask the
		remote party to transmit the docu-
		ment again.
E0	Error relating to the printer or mem-	Remove the cause of the error on
E6	ory.	the printer, if any. Then ask the re-
		mote party to retry the transmis-
		sion. If not corrected, call your ser-
		vice representative.
22	File Error due to a Directory Error	Power the unit ON/OFF, then retry.
30		Retry the transmission or ask the
	was pressed during the com-	remote party to transmit the docu-
		ment again.
	munication.
32	Page # Mismatch	Check the actual document count.
33	Polling Error	Check polling options setup (securi-
		ty code, etc.), and check if the poll-
		ing document exists.

Error	Cause	How to Correct
Code
42	Memory Overflow	Wait until the memory is recov-
		ered by completing some of the
		reserved jobs or remove other
		causes if any, then retry the com-
		munication. If problem is continu-
		al, acquire additional memory.
50	Line Busy	Send the document again.
53	Security Mismatch in Relay or	Confirm the remote party’s securi-
	Mailbox transmission	ty code, system password, and
		your setup.
B0-B5	Signal Error or Line Condition Error	Retry the communication. Fre-
C0-C4		quent failure may indicate a phone
D0-D2		line problem. If possible, move the
F0, F1		unit to another line and try your
		communications again.
87	No residual memory was remain-	Retry the transmission.
	ing on the remote party’s machine
	for Relay or Mailbox transmission.

229