Toshiba DP125F, Dp120F manual Direct Transmission as Default Setting

Direct Transmission

Direct Transmission is used if there is not enough residual memory or when a large num- ber of document pages are to be sent, etc.

This mode is also useful if the operator wishes to visually con- firm the actual transmission of

Direct Transmission as Default Setting

1 Load the Document	2 Dial the Facsimile	3 Start Dialing	4 Connect the Line to
	Number		the Remote Party

the document to the remote par- ty.

The documents will remain in the ADF and be transmitted one by one.

This procedure will discuss Di- rect Transmission when se- lected as the default setting or when Residual Memory has been depleted.

Load the document face down in the Document Tray (see page 88).

Adjust the resolution and con- trast if desired (see page 89).

MAY-17-00 WED11:49

RESIDUAL MEMORY 100% ENTER TEL NUMBER

Example of screen displayed when Residual Memory has been depleted:

MAY-17-00 WED11:49

RESIDUAL MEMORY 0% ENTER TEL NUMBER

Dial the facsimile number of the remote party using any of the four dialing methods.

•One Touch Key Dialing

... See page 97

•Abbreviated Dialing

... See page 98

•Alphabet Dialing

... See page 99

•Keypad Dialing

... See page 100

•Press if a dialing er-

ror occurs.

Example of screen displayed while a number is entered using Keypad Dialing:

COMM. RESERVATION

TEL NUMBER =(MAX128) 0559761234

Once the facsimile number is entered, the dialing starts.

DIALING
FILE NBR =	025

0559761234

If the destination facsimile is busy, the screen below is dis- played.

WAITING TO REDIAL

RESIDUAL MEMORY 100%

If the redial procedure is com- pleted without success, the screen below is displayed and this transmission job is can- celled.

MAY-17-00 WED11:59

LINE BUSY

Once connected to the destina- tion facsimile, the screen below is displayed.

COMMUNICATING

FILE NBR =	025
	0559761234

The remote party Terminal ID will be displayed as shown be- low.

	COMMUNICATING
FILE NBR =		025
+81 559	761234

103