3Com 3CRWEASYA73, WL-575 manual System Logging Commands, Show hardware, System Loggign Commands

CHAPTER 6: COMMAND LINE INTERFACE
SSH Server	: ENABLED
SSH Server Port	: 22
Telnet Server	: ENABLED
WEB Redirect	: DISABLED
DHCP Relay	: DISABLED

==============================================================

Version Information

=========================================

Version: v4.3.2.2

Date : Dec 20 2005, 18:38:12

=========================================

Outdoor 11a Building to Building #

show hardware

This command displays the hardware version of the system.

Command Mode

Exec

Example

Outdoor 11a Building to Building #show hardware

Hardware Version Information

===========================================

Hardware version R01

===========================================

Outdoor 11a Building to Building #

System Logging Commands

These commands are used to configure system logging on the access point.

Table 13 System Loggign Commands

Command	Function	Mode	Page
logging on	Controls logging of error messages	GC	6-33
logging host	Adds a syslog server host IP address that will receive	GC	6-33
	logging messages
logging console	Initiates logging of error messages to the console	GC	6-34
logging level	Defines the minimum severity level for event logging	GC	6-34
logging facility-type	Sets the facility type for remote logging of syslog	GC	6-35
	messages
logging clear	Clears all log entries in access point memory	GC	6-36
show logging	Displays the state of logging	Exec	6-36
show event-log	Displays all log entries in access point memory	Exec	6-37

6-32