3Com 3CRWEASYA73, WL-575 manual WDS Bridge Commands

CHAPTER 6: COMMAND LINE INTERFACE

Example

Outdoor 11a Building to Building #show filters

Protocol Filter Information

=======================================================================

Local Bridge	:Traffic	among all client STAs blocked
AP Management	:ENABLED
Ethernet Type Filter :DISABLED

UPlink Access Table

-----------------------------------------------------------------------

UPlink access control:Enabled

UPlink MAC access	control list	:
00-12-34-56-78-9a

-----------------------------------------------------------------------

Enabled Protocol Filters

-----------------------------------------------------------------------

No protocol filters are enabled

=======================================================================

Outdoor 11a Building to Building #

WDS Bridge Commands

The commands described in this section are used to set the operation mode for each access point interface and configure WIreless Distribution System (WDS) forwarding table settings.

Table 22 WDS Bridge Commands

Command	Function	Mode	Page
bridge mode	Selects Master or Slave mode.	IC-W	6-89
bridge role	Selects the bridge operation mode for a radio interface IC-W		6-89
bridge channel-auto-sync	Automatically finds the parent bridge operating	IC-W	6-90
	channel

CAUTION: Do not enable Channel Auto Sync on a master

! bridge if there is no root bridge acting as the master bridge's parent.

bridge-link parent	Configures the MAC addresses of the parent bridge	IC-W	6-90
	node
bridge-link child	Configures MAC addresses of connected child bridge	IC-W	6-91
	nodes
bridge dynamic-entry	Sets the aging time for dynamic entries in the WDS	GC	6-92
age-time	forwarding table
show bridge aging-time	Displays the current WDS forwarding table aging time Exec		6-94
show bridge filter-entry	Displays current entries in the bridge MAC address	Exec	6-95
	table
show bridge link	Displays current bridge settings for specified interfaces Exec		6-97

6-88