CHAPTER 6: COMMAND LINE INTERFACE

When the access point is operating in this mode, traffic is not forwarded to the Ethernet port from the radio interface.

Up to four WDS bridge links (MAC addresses) per radio interface can be specified for each unit in the wireless bridge network. One unit only must be configured as the “root bridge” in the wireless network. The root bridge is the unit connected to the main core of the wired LAN. Other bridges need to specify one “Parent” link to the root bridge or to a bridge connected to the root bridge. The other seven WDS links are available as “Child” links to other bridges.

The bridge link on the radio interface always uses the default VAP interface. In any bridge mode, VAP interfaces 1 to 7 are not available for use.

Example

Outdoor 11a Building to Building(if-wireless a)#bridge role root-bridge Outdoor 11a Building to Building(if-wireless a)#

bridge channel-auto-sync

CAUTION: Do not enable Channel Auto Sync on a master bridge if there is no

!root bridge acting as the master bridge's parent.

This command allows a child bridge to automatically find the operating channel of its parent bridge.

Syntax

bridge channel-auto-sync <enable disable>

enable - The bridge will automatically search and find the operating channel of its parent.

disable - The bridge must have the operating channel manually set to the operating channel of its parent bridge.

Default Setting

Disabled

Command Mode

Interface Configuration (Wireless)

Example

Outdoor 11a Building to Building(if-wireless a)#bridge channel-auto-sync enable

Enable channel auto sync!!

Outdoor 11a Building to Building(if-wireless a)#

6-90

Page 202
Image 202
3Com 3CRWEASYA73, WL-575 manual Syntax Bridge channel-auto-sync enable disable