3Com 3CRWEASYA73, WL-575 manual WMM Commands, Wmm, Syntax No wmm supported required

CHAPTER 6: COMMAND LINE INTERFACE

•If the VLAN ID has not been configured for a client on the RADIUS server, then the frames are tagged with the default VLAN ID of the VAP interface.

Example

Outdoor 11a Building to Building(if-wireless g: VAP[0])#vlan-id 3

Outdoor 11a Building to Building(if-wireless g: VAP[0])#

WMM Commands

The access point implements QoS using the Wi-Fi Multimedia (WMM) standard. Using WMM, the access point is able to prioritize traffic and optimize performance when multiple applications compete for wireless network bandwidth at the same time. WMM employs techniques that are a subset of the developing IEEE 802.11e QoS standard and it enables the access point to inter-operate with both WMM- enabled clients and other devices that may lack any WMM functionality.

The WMM commands supported by the access point are listed below.

Table 30 WMM Commands

Command	Function	Mode	Page
wmm	Sets the WMM operational mode on the access point	IC-W	6-158
wmm-acknowledge-	Allows the acknowledgement wait time to be enabled	IC-W	6-159
policy	or disabled for each Access Category (AC)
wmmparam	Configures detailed WMM parameters that apply to the	IC-W	6-160
	access point (AP) or the wireless clients (BSS)

wmm

This command sets the WMM operational mode on the access point. Use the no form to disable WMM.

Syntax

[no] wmm <supported required>

•supported - WMM will be used for any associated device that supports this feature. Devices that do not support this feature may still associate with the access point.

•required - WMM must be supported on any device trying to associated with the access point. Devices that do not support this feature will not be allowed to associate with the access point.

6-158