3Com WL-575, 3CRWEASYA73 manual Spanning Tree Commands, Bridge stp enable, Bridge Commands

Using the Command Line Interface

Outdoor 11a Building to Building#show bridge link ethernet

status	: Enabled
state	: Forwarding
priority	: 0
path cost	: 19
message age Timer	: Inactive
message age	: 4346
designated-root	: priority = 32768, MAC = 00:30:F1:F0:9A:9C
designated-cost	: 0
designated-bridge	: priority = 32768, MAC = 00:30:F1:F0:9A:9C
designated-port	: priority = 0, port No = 1

forward-transitions : 1

Outdoor 11a Building to Building#

Spanning Tree Commands

The commands described in this section are used to set the MAC address table aging time and spanning tree parameters for both the Ethernet and wireless interfaces.

Table 23 Bridge Commands

Command	Function	Mode	Page
bridge stp enable	Enables the Spanning Tree feature	GC	6-99
bridge stp forwarding-delay	Configures the spanning tree bridge forward time	GC	6-100
bridge stp hello-time	Configures the spanning tree bridge hello time	GC	6-101
bridge stp max-age	Configures the spanning tree bridge maximum age	GC	6-101
bridge stp priority	Configures the spanning tree bridge priority	GC	6-102
bridge-link path-cost	Configures the spanning tree path cost of a port	IC	6-103
bridge-link port-priority	Configures the spanning tree priority of a port	IC	6-104
show bridge stp	Displays the global spanning tree settings	Exec	6-104
show bridge link	Displays current bridge settings for specified interfaces Exec		6-97

bridge stp enable

This command enables the Spanning Tree Protocol. Use the no form to disable the Spanning Tree Protocol.

6-99