CHAPTER 6: COMMAND LINE INTERFACE

Syntax

bridge stp max-age <seconds>

no bridge stp max-age

seconds - Time in seconds. (Range: 6-40 seconds)

The minimum value is the higher of 6 or [2 x (hello-time + 1)].

The maximum value is the lower of 40 or [2 x (forward-time - 1)].

Default Setting

20 seconds

Command Mode

Global Configuration

Command Usage

This command sets the maximum time (in seconds) a device can wait without receiving a configuration message before attempting to reconfigure. All device ports (except for designated ports) should receive configuration messages at regular intervals. Any port that ages out STP information (provided in the last configuration message) becomes the designated port for the attached LAN. If it is a root port, a new root port is selected from among the device ports attached to the network.

Example

Outdoor 11a Building to Building(config)#bridge stp max-age 40

Outdoor 11a Building to Building(config)#

bridge stp priority

Use this command to configure the spanning tree priority globally for the wireless bridge. Use the no form to restore the default.

Syntax

bridge stp priority<priority> no bridge stp priority

priority - Priority of the bridge. (Range: 0 - 65535)

6-102

Page 214
Image 214
3Com 3CRWEASYA73, WL-575 manual Syntax Bridge stp max-age seconds No bridge stp max-age, Bridge stp priority