3Com 3CRWEASYA73, WL-575 manual Syntax Snmp-server user user-name

CHAPTER 6: COMMAND LINE INTERFACE

Example

Outdoor 11a Building to Building(config)#snmp-server engine-id 1a:2b:3c:4d:00:ff

Outdoor 11a Building to Building(config)#

snmp-server user

This command configures the SNMP v3 users that are allowed to manage the access point. Use the no form to delete an SNMP v3 user.

Syntax

snmp-server user <user-name>

user-name- A user-defined string for the SNMP user. (32 characters maximum)

Default Setting

None

Command Mode

Global Configuration

Command Usage

•Up to 10 SNMPv3 users can be configured on the access point.

•The SNMP engine ID is used to compute the authentication/privacy digests from the pass phrase. You should therefore configure the engine ID with the snmp-serverengine-idcommand before using this configuration command.

•The access point enables SNMP v3 users to be assigned to three pre-defined groups. Other groups cannot be defined. The available groups are:

-RO - A read-only group using no authentication and no data encryption. Users in this group use no security, either authentication or encryption, in SNMP messages they send to the agent. This is the same as SNMP v1 or SNMP v2c.

-RWAuth - A read/write group using authentication, but no data encryption. Users in this group send SNMP messages that use an MD5 key/password for authentication, but not a DES key/password for encryption.

-RWPriv - A read/write group using authentication and data encryption. Users in this group send SNMP messages that use an MD5 key/password for authentication and a DES key/password for encryption. Both the MD5 and DES key/passwords must be defined.

6-52