3Com WL-575, 3CRWEASYA73 manual System Management Commands, Country

Using the Command Line Interface

System Management Commands

These commands are used to configure the user name, password, system logs, browser management options, clock settings, and a variety of other system information.

Table 11 System Management Commands

Command	Function	Mode	Page
Country Setting
country	Sets the access point country code	Exec	6--13
Device Designation
prompt	Customizes the command line prompt	GC	6--15
system name	Specifies the host name for the access point	GC	6-16
snmp-server contact	Sets the system contact string	GC	6-46
snmp-server location	Sets the system location string	GC	6-47
Management Access
username	Configures the user name for management access	GC	6-16
password	Specifies the password for management access	GC	6-17
ip ssh-server enable	Enables the Secure Shell server	IC-E	6-17
ip ssh-server port	Sets the Secure Shell port	IC-E	6-18
ip telnet-server enable	Enables the Telnet server	IC-E	6-18
APmgmtIP	Specifies an IP address or range of addresses allowed access	GC	6-23
	to the management interface
APmgmtUI	Enables or disables SNMP, Telnet or web management access GC		6-24
show APmanagement	Shows the AP management configuration	Exec	6-25
Web Server
ip http port	Specifies the port to be used by the web browser interface	GC	6-19
ip http server	Allows the access point to be monitored or configured from	GC	6-19
	a browser
ip https port	Specifies the UDP port number used for a secure HTTP	GC	6-20
	connection to the access point’s Web interface
ip https server	Enables the secure HTTP server on the access point	GC	6-21
web-redirect	Enables web authentication of clients using a public access	GC	6-22
	Internet service
System Status
show system	Displays system information	Exec	6-26
show version	Displays version information for the system	Exec	6-27
show config	Displays detailed configuration information for the system	Exec	6-27
show hardware	Displays the access point’s hardware version	Exec	6-32

country

This command configures the access point’s country code, which identifies the country of operation and sets the authorized radio channels.

6-13