CHAPTER 6: COMMAND LINE INTERFACE

Command Mode

Interface Configuration (Ethernet)

Command Usage

The access point supports Secure Shell version 2.0 only.

After boot up, the SSH server needs about two minutes to generate host encryption keys. The SSH server is disabled while the keys are being generated. The show system command displays the status of the SSH server.

Example

Outdoor 11a Building to Building(if-ethernet)#ip ssh-server enable

Outdoor 11a Building to Building(if-ethernet)#

ip ssh-server port

This command sets the Secure Shell server port. Use the no form to disable the server.

Syntax

ip ssh-server port <port-number>

port-number- The UDP port used by the SSH server. (Range: 1-65535)

Default Setting

22

Command Mode

Interface Configuration (Ethernet)

Example

Outdoor 11a Building to Building(if-ethernet)#ip ssh-server port 1124

Outdoor 11a Building to Building(if-ethernet)#

ip telnet-server enable

This command enables the Telnet server. Use the no form to disable the server.

Syntax

ip telnet-server enable no ip telnet-server

Default Setting

Interface enabled

6-18

Page 130
Image 130
3Com 3CRWEASYA73, WL-575 Syntax Ip ssh-server port port-number, Default Setting Command Mode, Ip telnet-server enable