CHAPTER 5: SYSTEM CONFIGURATION

„Prevent Intra VAP client communication: When enabled, clients associated with a specific VAP interface cannot establish wireless communications with each other. Clients can communicate with clients associated to other VAP interfaces.

„Prevent Inter and Intra VAP client communication: When enabled, clients cannot establish wireless communications with any other client, either those associated to the same VAP interface or any other VAP interface.

AP Management Filter – Controls management access to the access point from wireless clients. Management interfaces include the web, Telnet, or SNMP. (Default: Disabled)

„Disabled: Allows management access from wireless clients.

„Enabled: Blocks management access from wireless clients.

Uplink Port MAC Address Filtering Status – Prevents traffic with specified source MAC addresses from being forwarded to wireless clients through the access point. You can add a maximum of eight MAC addresses to the filter table. (Default: Disabled)

„MAC Address: Specifies a MAC address to filter, in the form xx-xx-xx-xx-xx-xx.

„Permission: Adds or deletes a MAC address from the filtering table.

Ethernet Type Filter – Controls checks on the Ethernet type of all incoming and outgoing Ethernet packets against the protocol filtering table. (Default: Disabled)

„Disabled: Access point does not filter Ethernet protocol types.

„Enabled: Access point filters Ethernet protocol types based on the configuration of protocol types in the filter table. If the status of a protocol is set to “ON,” the protocol is filtered from the access point.

NOTE: Ethernet protocol types not listed in the filtering table are always forwarded by the access point.

5-16

Page 64
Image 64
3Com 3CRWEASYA73, WL-575 manual System Configuration