Using the Command Line Interface

changes before it starts to forward frames. In addition, each port needs time to listen for conflicting information that would make it return to the discarding state; otherwise, temporary data loops might result.

Example

Outdoor 11a Building to Building(config)#bridge stp forwarding-delay 20 Outdoor 11a Building to Building(config)#

bridge stp hello-time

Use this command to configure the spanning tree bridge hello time globally for the wireless bridge. Use the no form to restore the default.

Syntax

bridge stp hello-time <time>

no bridge stp hello-time

time - Time in seconds. (Range: 1-10 seconds).

The maximum value is the lower of 10 or [(max-age / 2) -1].

Default Setting

2 seconds

Command Mode

Global Configuration

Command Usage

This command sets the time interval (in seconds) at which the root device transmits a configuration message.

Example

Outdoor 11a Building to Building(config)#bridge stp hello-time 5 Outdoor 11a Building to Building(config)#

bridge stp max-age

Use this command to configure the spanning tree bridge maximum age globally for the wireless bridge. Use the no form to restore the default.

6-101

Page 213
Image 213
3Com WL-575, 3CRWEASYA73 manual Syntax Bridge stp hello-time time No bridge stp hello-time, Bridge stp max-age