138
File Management
Transferring Files Using the Flexible Disk Drive
To load a configuration
You can quickly load a previously saved configuration, so that you will
not have to manually set up the measurement parameters.
1Go to the System Hard Disk or System Flexible Disk menu.
Your choice here depends on where you saved the configuration.
2Select the field below System and select Load from the pop-up
menu.
3Select the destination from the module list.
"System" loads only settings available under the System menus.
"Analyzer" loads data and settings for the analyzer. "All" loads both the
system and analyzer configurations.
You can only load configuration files to the area from which the
configuration was taken. For instance, you cannot load an analyzer
configuration file to the system. Thus, if you select System, then select
a file that contains only an analyzer configuration, the configuration
will fail. The file type field tells you what type of information is in a file.
Analyzer configuration files show “167xan_config”, and system
configurations show "167x_cnfg" in the file type field.
4Specify a file name from which to load the configuration using
the from file field or scrolling with the knob.