32
Logic Analyzer Overview
Agilent Technologies 1670G-Series Logic Analyzer
Run measurement
Select single or repetitive
From any Analyzer menu, select the field labeled Run in the upper
right corner to start measuring, or press the Run key. A single run will
run once, until memory is full; a repetitive run will go until you select
Stop or until a stop measurement condition that you set in the markers
menu is fulfilled.
If nothing happens, see Troubleshooting the Logic
Analyzer
When you start a run, your analyzer menu changes to one of the display
menus or a status message pops up. If nothing happens, press the Stop
key or select Cancel. If the analyzer still does not display any
measurements, see "Troubleshooting the Logic Analyzer" on page 422.
Gather data
You can gather statistics automatically by going to the Waveform or
Listing menu, turning on markers, and setting patterns for the X and O
markers. You can set the analyzer to stop if certain conditions are
exceeded, or just use the markers to count valid runs.