260
Logic Analyzer Reference
Probing
Connecting the pattern generator pods directly to a PC board (pattern generator option only)
To connect the pattern generator pods directly to the PC board, use
one of the following two methods. Both methods require that a 3M
2520-series, or similar alternative connector be installed on the PC
board.

Direct pod to board connection

Simply plug the pod directly into the 3M 2520-series, or similar
alternative connector on the PC board.

Jumper cable to pod connection

Use this method when you have clearance problems on the PC board.
Construct a flat ribbon cable and connect as shown below.
Equivalent connectors can be obtained from sources other than 3M.