435
Troubleshooting the Logic Analyzer
Error Messages
"Timer is off in sequence level n where it is
used"
If you use timers as part of your trigger sequence, you must remember
to turn them on using Timer Control in the Sequence Level pop-up
menu.
❏Check that your timers are turned on. The timer status is shown in the
right side of the Sequence Level display of the Trigger menu. An "S" means
"Start", "P" means "Pause", "C" means "Continue", and "-" means "off".
"Timer is specified in sequence, but never
started"
This message often appears with "Timer is off in sequence level n
where it is used," but is not quite the same. That message refers to a
particular sequence level, but this message is a general warning that
the timer has not been set to Start in any level.
❏Start the timer in one of the levels before where it is used.
"Inverse assembler not loaded - bad object
code."
The inverse assembler file has been corrupted.
❏Try loading a different copy of the inverse assemb ler.