Agilent Technologies E4406A VSA manual Cross-OverPatch Cable Wiring cross-overend, Figure

Models: E4406A VSA

1 406
Download 406 pages 63.49 Kb
Page 112
Image 112
Cross-Over Patch Cable Wiring (cross-over end)

NOTE

NOTE

Figure 2-7

Programming Fundamentals

Using the LAN to Control the Analyzer

A convenient way to make a cross-over adapter is to use two RJ-45 jacks wired according to Table 2-4. Standard straight-through patch cables can then be used from the analyzer to the adapter, and from the adapter to other LAN devices. If you use a special-purpose adapter, you will avoid having a cross-over cable mistaken for a standard, straight-through patch cable.

Some commercially-available cross-over cables do not implement the cross-over wiring required for your analyzer. Please refer to Table 2-4, and verify all connections before using cables not made by Agilent Technologies.

Cross-Over Patch Cable Wiring (cross-over end)

112

Chapter 2

Page 112
Image 112
Agilent Technologies E4406A VSA Cross-OverPatch Cable Wiring cross-overend, Figure, Using the LAN to Control the Analyzer