Agilent Technologies E4406A VSA Adjacent Channel Power—DynamicRange, SENSe:ACP:DYNamicn:RANGem?

	Language Reference
	SENSe Subsystem
Remarks:	With measurement type set at (TPR) total power
	reference, 1.40 MHz is sometimes used. Using
	1.23 MHz will give a power that is very nearly identical
	to the 1.40 MHz value, and using 1.23 MHz will also
	yield the correct power spectral density with
	measurement type set at (PSD) reference. However, a
	setting of 1.40 MHz will not give the correct results
	with measurement type set at PSD reference.
	You must be in Basic, cdmaOne, cdma2000, W-CDMA
	(3GPP), W-CDMA (Trial & Arib), iDEN mode to use
	this command. Use INSTrument:SELect to set the
	mode.

Adjacent Channel Power—Dynamic Range

[:SENSe]:ACP:DYNamic[n]:RANGe[m] HIGHNORMalMODified

[:SENSe]:ACP:DYNamic[n]:RANGe[m]?

Select a dynamic range optimization.

High - chooses settings that provide better dynamic range (better signal to noise ratio) at the expense of longer measurement times. This is a better choice for CDMA signals with multiple carriers turned on at the same time.

Normal - lets the measurement automatically choose settings that trade off dynamic range for faster measurement speed. This is a good choice for making CDMA measurements on a signal with only one carrier turned on at a time.

Modified- is not a customer settable option. This choice is automatically selected depending on your selection of other related settings in the advanced measurement setup, like the number of FFT segments.

Dynamic[n] n=1 BTS, n=2 MS

Range[m] m=1 IS-95A, m=2 J-STD-008

–n=1, m=1 BTS and IS-95A

–n=1, m=2 BTS and J-STD-008

–n=2, m=1 MS and IS-95A

–n=2, m=1 MS and J-STD-008

Factory Preset
and *RST:	NORMal
Remarks:	You must be in the cdmaOne mode to use this
	command. Use INSTrument:SELect to set the mode.

Chapter 5 289