Agilent Technologies E4406A VSA manual Waveform—Decimationof Waveform Display

Models: E4406A VSA

1 406
Download 406 pages 63.49 Kb
Page 362
Image 362
Waveform—Decimation of Waveform Display

Language Reference

SENSe Subsystem

Waveform—Decimation of Waveform Display

[:SENSe]:WAVeform:DECimate[:FACTor] <integer>

[:SENSe]:WAVeform:DECimate[:FACTor]?

Set the amount of data decimation done on the IQ data stream. For example, if 4 is selected, three out of every four data points will be thrown away. So every 4th data point will be kept.

Factory Preset

 

and *RST:

1

Range:

1 to 4

Remarks:

To use this command, the appropriate mode should be

 

selected with INSTrument:SELect.

Waveform—Control Decimation of Waveform Display

[:SENSe]:WAVeform:DECimate:STATe OFFON01

[:SENSe]:WAVeform:DECimate:STATe?

Set the amount of data decimation done by the hardware in order to decrease the number of acquired points in a long capture time. This is the amount of data that the measurement ignores.

Factory Preset

 

and *RST:

OFF

Remarks:

To use this command, the appropriate mode should be

 

selected with INSTrument:SELect.

Waveform—Sweep (Acquisition) Time

[:SENSe]:WAVeform:SWEep:TIME <time>

[:SENSe]:WAVeform:SWEep:TIME?

Set the measurement acquisition time. It is used to specify the length of the time capture record.

Factory Preset

 

and *RST:

2.0 ms

 

10.0 ms, for NADC, PDC

 

15.0 ms, for iDEN mode

Range:

1 ∝s to 100 s

Default Unit:

seconds

362

Chapter 5

Page 362
Image 362
Agilent Technologies E4406A VSA manual Waveform—Decimationof Waveform Display, SENSe:WAVeform:DECimate:FACTor <integer>