Agilent Technologies E4406A VSA manual Select Application, INSTrumentSELect?

	Language Reference
	INSTrument Subsystem
Factory Preset
and *RST:	Persistent state with factory default of 8 (BASIC)
Range:	1 to x, where x depends upon which applications are
	installed.
Front Panel
Access:	Mode

Select Application

:INSTrument[:SELect]

BASICSERVICECDMACDMA2KGSMEDGEGSMIDENNADCPDC

WCDMAARIBWCDMA

	:INSTrument[:SELect]?
	Select the measurement mode. The actual available choices depend
	upon which modes (measurement applications) are installed in the
	instrument.A list of the valid choices is returned with the INST:CAT?
	query.
	Once an instrument mode is selected, only the commands that are valid
	for that mode can be executed.
	1	= SERVICE
	3	= GSM
	4	= CDMA (cdmaOne)
	5	= NADC
	6	= PDC
	8	= BASIC
	9	= WCDMA (W-CDMA, 3GPP)
	10 = CDMA2K (cdma2000)
	11 = IDEN
	12 = ARIBWCDMA (W-CDMA, ARIB and Trial)
	13 = EDGEGSM
	If you are using the status bits and the analyzer mode is changed, the
NOTE
	status bits should be read, and any errors resolved, prior to switching
	modes. Error conditions that exist prior to switching modes cannot be
	detected using the condition registers after the mode change. This is

true unless they recur after the mode change, although transitions of these conditions can be detected using the event registers.

Changing modes resets all SCPI status registers and mask registers to their power-on defaults. Hence, any event or condition register masks must be re-established after a mode change. Also note that the power up status bit is set by any mode change, since that is the default state after power up.

Chapter 5 253