Agilent Technologies E4406A VSA manual You must be in Basic, cdmaOne, cdma2000, W-CDMA, Remarks

Language Reference

SENSe Subsystem

Mode	Variant	Offset A	Offset B	Offset C	Offset D	Offset E
W-CDMA		On	On	Off	Off	Off
(3GPP)
W-CDMA (Trial		On	On	Off	Off	Off
& Arib)
	Remarks:	You must be in Basic, cdmaOne, cdma2000, W-CDMA
		(3GPP), or W-CDMA (Trial & Arib) mode to use this
		command. Use INSTrument:SELect to set the mode.

Adjacent Channel Power—Sweep Time

[:SENSe]:ACP:OFFSet:LIST:SWEep:TIME

<seconds>,<seconds>,<seconds>,<seconds>,<seconds>

[:SENSe]:ACP:OFFSet:LIST:SWEep:TIME?

Selects a specific sweep time. If you increase the sweep time, you increase the length of the time data captured and the number of points measured. You might need to specify a specific sweep speed to accommodate a specific condition in your transmitter. For example, you may have a burst signal and need to measure an exact portion of the burst.

Selecting a specific sweep time may result in a long measurement time

since the resulting number of data points my not be the optimum 2n. Use [:SENSe]:ACP:SWEep:TIME to set the number of points used for measuring the reference channel.

You can turn off (not use) specific offsets with the

SENS:ACP:OFFSet:LIST:STATe command.

Factory Preset and *RST:

Mode	Offset A	Offset B	Offset C	Offset D	Offset E
Basic &	11.20 ms	11.20 ms	11.20 ms	11.20 ms	11.20 ms
cdmaOne
Range:	1 ∝s to 50 ms
Default Unit:	seconds
Remarks:	You must be in Basic, cdmaOne mode to use this
	command. Use INSTrument:SELect to set the mode.
History:	Revision A.03.00 or later, in cdmaOne revision A.04.00

Chapter 5 309