Agilent Technologies E4406A VSA manual Marker On/Off, CALCulate:<measurement>:MARKer1|2|3|4:STATe?

Language Reference

CALCulate Subsystem

Marker On/Off

:CALCulate:<measurement>:MARKer[1]234[:STATe] OFFON01

:CALCulate:<measurement>:MARKer[1]234[:STATe]?

Turns the selected marker on or off.

The marker must have already been assigned to a trace. Use :CALCulate:<measurement>:MARKer[1]234:TRACe to assign a marker to a particular trace.

Example:	CALC:SPEC:MARK2: on
Remarks:	The keyword for the current measurement must be
	specified in the command. (Some examples include:
	SPECtrum, AREFerence, WAVeform)
	The WAVeform measurement only has two markers
	available.
Front Panel	Marker, Select then Marker Normal or Marker On Off
Access:

Marker to Trace

:CALCulate:<measurement>:MARKer[1]234:TRACe <trace_name>

:CALCulate:<measurement>:MARKer[1]234:TRACe?

Assigns the specified marker to the designated trace. Not all types of measurement data can have markers assigned to them.

Example:	With the WAVeform measurement selected, a valid
	command is CALC:SPEC:MARK2:TRACE rfenvelope.
Range:	The names of valid traces are dependent upon the
	selected measurement. See the following table for the
	available trace names. The trace name assignment is
	independent of the marker number.
Remarks:	The keyword for the current measurement must be
	specified in the command. (Some examples include:
	SPECtrum, WAVeform)

Front PanelAccess: Marker, Marker Trace

Chapter 5 207