Agilent Technologies E4406A VSA manual SENSe:ACP:AVERage:TCONtrol EXPonential|REPeat

Language Reference

SENSe Subsystem

Adjacent Channel Power—Averaging Termination Control

[:SENSe]:ACP:AVERage:TCONtrol EXPonentialREPeat

[:SENSe]:ACP:AVERage:TCONtrol?

Select the type of termination control used for averaging. This determines the averaging action after the specified number of data acquisitions (average count) is reached.

EXPonential – Each successive data acquisition after the average count is reached, is exponentially weighted and combined with the existing average.

REPeat – After reaching the average count, the averaging is reset and a new average is started.

Factory Preset
and *RST:	REPeat for basic, cdmaOne, cdma2000, W-CDMA
	(3GPP), W-CDMA (Trial & Arib)
	EXPonential for NADC, PDC, iDEN
Remarks:	Use INSTrument:SELect to set the mode.

Adjacent Channel Power—Type of Carrier Averaging

[:SENSe]:ACP:AVERage:TYPE MAXimumRMS

[:SENSe]:ACP:AVERage:TYPE?

Selects the type of averaging to be used for the measurement of the carrier.

Factory Preset
and *RST:	RMS
Remarks:	You must be in Basic, cdmaOne mode to use this
	command. Use INSTrument:SELect to set the mode.
History:	Revision A.03.00 or later, in cdmaOne revision A.04.00
Front Panel
Access:	Meas Setup, Avg Mode

Adjacent Channel Power—Carrier Channel BW

Basic, cdmaOne, iDEN mode

[:SENSe]:ACP:BANDwidthBWIDth:INTegration <freq>

[:SENSe]:ACP:BANDwidthBWIDth:INTegration?

cdma2000, W-CMDA (3GPP) mode

Chapter 5 287