Agilent Technologies E4406A VSA manual CALC:DATA2:COMP? MEAN,24e-6,526e-6 These

			Language Reference
			CALCulate Subsystem
	Example:	To query the mean power of a set of GSM bursts:
		1. Set the waveform measurement sweep time to
		acquire at least one burst.
		2. Set the triggers such that acquisition happens at a
		known position relative to a burst.
		3. Then query the mean burst levels using,
		CALC:DATA2:COMP? MEAN,24e-6,526e-6 (These
		parameter values correspond to GSM signals, where
		526e-6 is the length of the burst in the slot and you
		just want 1 burst.)
	There is a more detailed example in the “Improving the Speed of Your
NOTE
	Measurements” section in the E4406A programmer’s guide.
	Remarks:	The optional parameters must be entered in the
		specified order. For example, if you want to specify
		<length>, you must also specify <soffset>.
		This command uses the data in the format specified by
		FORMat:DATA, returning either binary or ASCII data.
	History:	Added in revision A.03.00
		Changed in revision A.05.00
	Measurement		Available Traces	Markers
				Available?
	ACP - adjacent channel power		no traces	no markers
	(Basic, cdmaOne, cdma2000, W-CDMA
	(3GPP), iDEN, NADC, PDC modes)
	BER - bit error rate		no traces	no markers
	(iDEN mode)
	CDPower - code domain power		POWer (n=2)a	yes
	(cdmaOne mode)		TIMing (n=3)a
			PHASe (n=4)a
	CDPower - code domain power		CDPower (n=2)a	yes
	(cdma2000, W-CDMA (3GPP) modes)		EVM (n=5)a
			MERRor (n=6)a
			PERRor (n=7)a
			SPOWer (n=9)a
			CPOWer (n=10)a

Chapter 5 197