Anritsu Series MS278XB VSA Modulation Parameters Setup Dialog, Modulation Settings, Format

Parameter Entry and Measurement Setup Dialog Archive Front Panel Menus

VSA Modulation Parameters Setup Dialog

The VSA Modulation Parameters dialog allows you to specify the modulation setting for your measurement.

	Modulation Settings:
	Format:
	BPSK: Binary Phase Shift Keying
	QPSK: Quadrature Phase Shift Keying (default)
	Pi4QPSK: Pi/4 Quadrature Phase Shift Keying
	8PSK: Octet Phase Shift Keying
	3Pi8PSK: 3Pi/8 Phase Shift Keying
Modulation Tab	16QAM: 16 Value Quadrature Amplitude Modulation
	32QAM: 32 Value Quadrature Amplitude Modulation
	64QAM: 64 Value Quadrature Amplitude Modulation
	128QAM: 128 Value Quadrature Amplitude Modulation
	256QAM: 256 Value Quadrature Amplitude Modulation
	Symbol Rate: Sets the symbol rate for the
	measurement.
	Range: 10 kHz to 20 MHz
	Default: 3.84 MHz.
	Capture Time: Sets the length of the time during which
	samples are captured.
	Range: 1s to 5 µs*
	Terminators: us, ms, s, ks, Cancel
	* Constrained by the following:
	10,000 ≥ (Symbol Rate x Capture Time ≥ 100
	Filtering:
	Filter Type: Selects from the following receiver filters:
	Low Pass
	Nyquist
	Root Nyquist (default)
	Rolloff Factor: Sets the roll-off factor for the
	measurement.
	Range: 0.1 to 1.0 in steps of 0.01
	Default: 0.22.
Figure 4-19.VSA Modulation Parameters Dialog

4-46 MS278XB OM