Parameter Entry and Measurement Setup Dialog Archive | Front Panel Menus |
|
|
ACP Reference Tab |
|
| ACP Reference Channel Selection Mode: |
| Selects the adjacent channel power reference |
| mode of: |
| Select Channel |
| Highest Power Channel |
| Lowest Power Channel |
| Channel #: Enter the channel number for the |
| reference (channel 1 through 12). |
| Range: Integers from +1 to +12 |
| (Do not enter negative numbers) |
| Default: 12 |
| /Hz: Toggles the result display between dBm or |
| dBm/Hz. The measurement type must be set to |
| Abs before /Hz can be toggled on. |
Advanced Tab | Type: Toggles between an absolute or relative |
measurement. | |
| Noise Compensation: When noise compensation |
| is toggled on, a noise floor measurement is |
| subtracted from the channel power. |
| FFT: Toggles between FFT or Swept modes. |
| Start Time: Sets the start of the measurement |
| relative to a triggered event (currently not |
| available). |
| Stop Time: Sets the stop time of the |
| measurement relative to a triggered event |
| (currently not available). |
| RRC Filter: This is used to turn the |
| cosine filter (RRC) On or Off. |
| Rolloff Factor: Sets the |
| measurement (RRC filter must be on). |
| Range: 0.1 to 1.0 in steps of 0.01 |
| Default: 1 |
| Bandwidth: Sets the bandwidth for the |
| measurement (RRC filter must be on). |
| Range: 1 Hz to 8 GHz |
| Default: 3.84 MHz |
Figure |
|
MS278XB OM |
