Front Panel Menus | Parameter Entry and Measurement Setup Dialog Archive |
Channel Power Setup Dialog
Channel Power measures the power and power spectral density in the channel bandwidth that you specify in the following dialogs:
Channel Power Tab | Channel BW: Sets the bandwidth over which the measurement |
| is made. This is typically larger than the actual signal |
| bandwidth. |
| Range: 1 Hz to 8 GHz in steps of 1 Hz |
| Default: 5 MHz |
| Method: Currently not available. |
| RRC Filter: This is used to turn the |
| (RRC) On or Off. |
| Rolloff Factor: Sets the |
| (RRC filter must be on). |
| Range: 0.1 to 1.0 in steps of 0.01 |
| Default: 0.22. |
| Symbol Rate: Sets the symbol rate for the measurement (RRC |
| filter must be on). |
| Range: 1 Hz to 8 GHz in steps of 1 Hz |
| Default: 3.84 MHz. |
|
|
Advanced Tab | /Hz: Toggles the result display between dBm or |
| dBm/Hz. The measurement type must be set to Abs before the |
| /Hz can be toggled on. |
| Type: Toggles between an absolute or relative measurement. |
| Noise Compensation: When noise compensation is toggled |
| on, a noise floor measurement is subtracted from the channel |
| power. |
| FFT: Toggles between FFT or Swept modes. |
| Start Time: Sets the start of the measurement relative to a |
| triggered event (currently not available). |
| Stop Time: Sets the stop time of the measurement relative to a |
| triggered event (currently not available). |
|
|
Figure 4-14. Channel Power Setup Dialog
MS278XB OM |
