Measurements | Measurement Examples |
Displaying Detectors
The following example shows an example of a 1 GHz carrier using the Average, RMS, Minimum, and Maximum detectors:
1.Preset the analyzer using the Preset button.
2.Set the center frequency to 1 GHz and the span to 300 kHz.
3.On the Trace Config menu, set the Trace 1 detector to Average.
4.Select Trace 2 as the active trace and set it’s detector to RMS.
5.Select Trace 3 as the active trace and set it’s detector to Minimum.
6.Select Trace 4 as the active trace and set it’s detector to Maximum. The display should look like the one in the figure below:
Figure 5-6. Displaying Detector Modes
MS278XB OM |
