Anritsu Series MS278XB operation manual ACP Tab 2

Front Panel Menus		Parameter Entry and Measurement Setup Dialog Archive
	ACP Tab (2 of 2)		Alt2 Channel: Toggles the Alt2 channel
			measurement off or on.
			Alt2 Channel Width: Sets the bandwidth of the Alt2
			channel.
			Range: 1 Hz to 8 GHz
			Default: 5 MHz
			Alt2 Channel Spacing: Sets the spacing between
			the main and Al2 channel.
			Range: 1 Hz to 8 GHz
			Default: 15 MHz
			RRC Filter: This is used to turn the root-raised-cosine
			filter (RRC) On or Off.
			Rolloff Factor: Sets the roll-off factor for the
			measurement (RRC filter must be on).
			Range: 0.1 to 1.0 in steps of 0.01
			Default: 0.22.
			Bandwidth: Sets the bandwidth for the measurement
			(RRC filter must be on).
			Range: 1 Hz to 8 GHz
			Default: 3.84 MHz.
	Advanced Tab
			/Hz: Toggles the result display between dBm or
			dBm/Hz. The measurement type must be set to Abs
			before /Hz can be toggled on.
			Type: Toggles between an absolute or relative
			measurement.
			Noise Compensation: When noise compensation is
			toggled on, a noise floor measurement is subtracted
			from the channel power.
			FFT: Toggles between FFT or Swept modes.
			Start Time: Sets the start of the measurement
			relative to a triggered event (currently not available).
			Stop Time: Sets the stop time of the measurement
			relative to a triggered event (currently not available).

Figure 4-15.Adjacent Channel Power Setup Dialog

MS278XB OM 4-39