Canon FAX-L800 manual Outside Image

5.TX TERMINAL ID	Print your ID (transmitting terminal ID) on each page you transmit.
	(Q3-11)
ON	After you turn the terminal ID ON, you can do the following
	settings.
	1.TTI POSITION
	OUTSIDE IMAGE	Terminal ID prints outside the image
		border
	INSIDE IMAGE	Terminal ID prints inside the image
		border.
	2.TELEPHONE # MARK	You can pre®x your number with the
		abbreviations FAX or TEL in your
		sender ID.
	FAX	Pre®xes the number with the
		abbreviation FAX.
	TEL	Pre®xes the number with the
		abbreviation TEL.
OFF	No terminal ID is not printed on the pages you send.
6.DENSITY CONTROL	Adjust the scanning density from 1-5 for DK (2 is default), 2-6 for
	STD (4 is default), 3-7 for LT (6 is default).

7.SCAN RESOLUTION Set the default value for the SUPER FINE setting of the RESOLUTION button on the operation panel. (Q6-4)

SUPER FINE	Scans at 8 dots/mm, 15.4 lines/mm.
ULTRA FINE	Scans at 16 dots/mm, 15.4 lines/mm.
8.PROGRAM KEY	Use the program button to streamline the procedures for printing
	activity reports or doing the scanner settings. (Q12-4)
PRINT REPORT	Press the PROGRAM button whenever you need a transmission
	report for a document you are sending.
REPORT	If you select this setting, you do not have to open both One-touch
	Speed Dialling panels to start printing a report. Whenever you need
	to print a report, press the PROGRAM button.
SCANNING MODE	Set the scanner buttons (Resolution, Contrast, Document Type) for
	special settings, like sending a photograph for example. Then you can
	adjust all the settings just by pressing the PROGRAM button.
STAMP	If you have installed the optional stamp feature, this option is
	available. If you select STAMP you can turn the stamp feature on or
	off without opening both One-touch Speed Dialling panels to press
	the STAMP button.

Chapter 16 Summary of Important Settings 16-5