FM-3 Programming Module Reference Manual
To select one of the individual setup views, click on the element in the hierarchy view. The element will then be highlighted, and the right side of the view will show all setup parameters for that subject. Figure 73 shows the Setup view selected.
Figure 73: General Setup View
On this view, you must enter the following parameters before entering other setup views:
Drive Type – Select, from the list box, the type of drive to which the
Motor Type – Select, from the list box, the type of motor being used in this application.
EN EN Only
Line Voltage – Select, from the list box, the line voltage applied (115VAC or 230VAC).
Target Drive Address – Enter the Modbus address for this
Please take the time to check that these parameters are correct.
