Emerson Process Management 2400S manual Device Profile

Device Profile

C.2 Analog Input Point Object (0x0A)

Table C-1Analog Input Point Object (0x0A) – Instance 1 (mass flow)

Attrib
ID	Name	Data type	Service	Mem	Description	Comments
3	Value	REAL	Get	V	Current value of mass	Based on Attribute 8
					flow process variable
4	Status	BOOL	Get	V	Point status	• 0 = Good
						• 1 = Alarm state
8	Value data type	USINT	Get	V	Data type used to report	• 1 = REAL
					mass flow process
					variable
100	Process total	REAL	Get	V	Current value of mass
			Reset(1)		total
101	Inventory total	REAL	Get	V	Current value of mass
			Reset(2)		inventory
102	Value	UINT	Set	NV	Mass flow measurement	See Table 6-2for unit
	engineering				unit	codes.
	units
103	Total	UINT	Get	V	Mass total and inventory	Transmitter
	engineering				units	automatically
	units					determines this based
						on Attribute 102.
						See Table C-12for unit
						codes.
104	Damping	REAL	Set	NV	Flow damping value	• Unit = seconds
						• Applied to both mass
						flow and liquid volume
						flow
105	Cutoff	REAL	Set	NV	Value below which mass
					flow will be reported as 0
106	Meter factor	REAL	Set	NV	A multiplier to the
					calculated mass flow
107	Flow direction	USINT	Set	NV	Determines how flow	• 0 = Forward only
					direction affects reported	• 1 = Reverse only
					flow rate and flow totals	• 2 = Bidirectional
						• 3 = Absolute value
						• 4 = Negate/forward
						only
						• 5 = Negate/
						bidirectional
108	Reset mass total	USINT	Set	V	Resets the mass total	• 1 = Reset
109	Reset mass	USINT	Set	V	Resets the mass	• 1 = Reset
	inventory				inventory

(1)Service code 0x4B.

(2)Service code 0x4C.

144 Micro Motion® Model 2400S Transmitters for DeviceNet™