Emerson Process Management 2400S manual Gas Standard Volume Object

Device Profile

Table C-3Analog Input Point Object (0x0A) – Instance 3 (density) continued

Attrib
ID	Name	Data type	Service	Mem	Description	Comments
104	Damping	REAL	Set	NV	Density damping value	Unit = seconds
105	Cutoff	REAL	Set	NV	Value below which density
					will be reported as 0
106	Meter factor	REAL	Set	NV	A multiplier to the
					calculated density

Table C-4Analog Input Point Object (0x0A) – Instance 4 (temperature)

Attrib
ID	Name	Data type	Service	Mem	Description	Comments
3	Value	REAL	Get	V	Current value of	Based on Attribute 8
					temperature process
					variable
4	Status	BOOL	Get	V	Point status	• 0 = Good
						• 1 = Alarm state
8	Value data type	USINT	Get	V	Data type used to report	• 1 = REAL
					mass flow process
					variable
102	Value	UINT	Set	NV	Temperature	See Table 6-6for unit
	engineering				measurement unit	codes.
	units
104	Damping	REAL	Set	NV	Temperature damping	Unit = seconds
					value

C.3	Gas Standard Volume Object (0x64)
Table C-5Gas Standard Volume Object (0x64) – Instance 1
Attrib
ID	Name	Data type	Service	Mem	Description	Comments
1	Gas standard	REAL	Get	V	Current value of gas
	volume flow				standard volume flow
					process variable
2	Gas standard	REAL	Get	V	Current value of gas
	volume total		Reset(1)		standard volume total
3	Gas standard	REAL	Get	V	Current value of gas
	volume		Reset(2)		standard volume
	inventory				inventory
4	Reference	REAL	Set	NV	Reference density of gas
	density				being measured
5	Gas standard	UINT	Set	NV	Gas standard volume flow	See Table 6-4for unit
	volume flow				measurement unit	codes.
	units
6	Gas standard	UINT	Get	V	Gas standard volume total	Transmitter
	volume total and				and inventory units	automatically
	inventory units					determines this based
						on Attribute 102.

See Table C-14for unit codes.

146 Micro Motion® Model 2400S Transmitters for DeviceNet™